2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.. ASTM Standards. B829 Specification for General Requirements for Nickel and Nickel Alloys Seamless Pipe and Tube. B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
ASTM B829 - Standard Specification for General ASTM B163 - Standard Specification for Seamless Nickel and Nickel Alloy Condenser and Heat-Exchanger Tubes Published by ASTM on November 1, 2019 This specification2 covers seamless tubes of nickel and nickel alloys, as shown in Table 1, for use in condenser and heat-exchanger service.
Standard:ASTM B163; ASTM B167; ASTM B444; ASTM B622 ect Process Method:Cold Drawn or Cold Rolled Application:Chemical and petrochemical process piping, heat exchangers, furnace components, carburizing equipment, heating-element sheathing, and nuclear power steam-generator tubing.
Monel 400 Seamless Tube ASTM B163 UNS N04400 Alloy Monel 400 Tube. To all intents and purpose in typical environmental conditions, the Monel Alloy 400 Tubing is immune to chloride-ion stress related corrosion cracking.And from sub-zero temperatures up to an elevated point of 1020° F Nickel 400 Cold Drawn Tube has good mechanical properties.. ASTM B163 Alloy 400 Tubing has high strength and toughness over a wide temperature range and excellent
Monel Tube Seamless, Monel Welded Tubing, Monel While ASTM B730, is a specification which covers welded tubes , ASTM B163 is a specification covers seamless variety of tubes. ASTM B730 Monel High Pressure Tube is available in the market in the form of two conditions i.e. welded and annealed condition or in a welded and stress relieved condition.
ASTM B163 specification covers seamless tubes of nickel and nickel alloy for use in condenser and heat-exchanger service. This covers outside diameter and average wall, or outside diameter and minimum wall tube. Alloy UNS N08800 is normally employed in service temperatures up to and including 1100°F (593°C). Alloys UNS N08810, UNS N08811, and UNS N08120 are normally employed in service Inconel Tube and ASTM B163 Inconel Alloy Seamless / ASTM B163 is the standard specification Inconel Condenser and Heat-Exchanger Tubes. These high temperature Inconel tubes are available at dimensions between 12.70 mm and 38.10mm OD. Steel Tubes India is 5th largest supplier of Inconel seamless tubes, supplied bright annealed in the outside diameter range 6 42 mm (0.25 in 1.625 in) and